Fw: MT Signals Scalper

On the attached 10 min ES chart I applied the above indicator but no signals/ indications appeared on the chart.
Please advise what settings are the optimum to see indications on chart.

Thank you.

Sincerely

Bobby

Hi

All of the MicroTrends NinjaTrader Framework Signals indicators and strategies have a common interface of parameters for you to work with.
Trade Setup
Trade Entry
Trade Exit (optional)

See the descripton of each setup and trade parameter it will tell you what options are.

Some of the indicators have a series of options for setup and entry that can be mxed together, so be default on a few the setup mode 0 = Off.
These setup and trade entry parameters are known as bitwise flags unless otherwise stated.
Bitwse flags run in a combinaton like this:
0:0ff, On: 1,2,4,8,16,32,64,128,256.....

To turn each flag/switch on you add them together.
So you can switch on modes 1 and 2 = enter 4 as the Parameter value.

See the descripton of each setup and trade parameter
If this is a logical and parameter - this means both conditions 1 and 2 have to be met.
So if they were for a long signal.

So for example in for a system that has 2 parameters for a long setup
1:Long Bull Candle
2:Long Close Above MA

Long Signal= bull candle and closes above an MA

If the parameters were Logical OR

Long Signal = bull candle or any candle that closes above an MA

Green Dots are Setup Buy
Green Triangles Trade Entry Buy
Red Dots are Setup Sell
Red Triangles Dots are Trade Entry Sell

MT Signals Sclalper

Setup Mode Flags are bitwse
1 to 64
1,2,4,8,16,32,64

For your purposes: Set the Setup Mode Parameter to 1
1=Close

To test eacb of the other flags/Modes
enter
1
2
4
8
16
32
64
To test all combinations at the same time = 127

This means all 1 to 64 needs to be true for a signal to fire.

More conditons does not mean better probability.

It is simply an extensible way of writing software that you have 100% control over.